What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
15.06.2025 05:12

2024–10–16 [ OO OLAOYE OYEBODE ]
What does a fuse do?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
At least they know the answer if they wanted it.
Barnstars:
eight
Do you consider masturbating to porn cheating if you are married?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
But… the neutral is now “floating” because of the 1 ohm resistance.
the problem then depends on "how fast does the fuse operate?".
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Was Daenerys' downfall inevitable after she left Meereen in Game of Thrones?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Now when you have a certain ac resistance, then a current flows in a loop.
It also is a device that limits the change in current flow.
What are some dirty secrets of Indian (Bollywood, etc.) actors and actresses?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
He then describes the function of a fuse.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Which bands became massively popular for covering songs rather than recording originals?
This is where the MOV conducts again, and dissipated the energy.
For this case there are devices called Metal oxide varistors (MOV).
But it can get overloaded, and no longer works.
What shocking family behavior did you read about in India?
First Sentence:
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Because the load is inductive, the current lags the voltage.(by a bit).
These are simplified answers to the original question, and does not change anything I wrote above.
[old diagram got deleted by accident]
What is lightning?
A fuse is a non-resetable over current circuit protector.
He then asserts :
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Can anyone or anything overthrow your belief in the Jewish God?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–10[John johnson John Johnson ]
The other is “what does a “fuse” do?”
a photo is worth a thousand words.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
2024–10–14 [Omar Gharbi Omar Gharbi ]
What's an underrated/unknown novel or series that you think deserves more attention?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This one hit behind the barn.
Edit 2024–10.
Coating satellites with super-black paint Vantablack could help fight light pollution crisis - Space
Can the fuse protect the electronic devices from lightning instead of a surge protector.
but this device (an Inductor) … impedes the rapid changes in the current.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
How much does a doctor earn in Sweden per month?
A circuit breaker is similar, but is resettable.
One
He then describes Rainy Season and Lightning.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
The MOV will conduct when the voltage exceeds 50% of line voltage.
nine
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
The third is lightning and “how it gets conducted into a home.”
This device then solves the entire problem.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
At one ohm, the resistor has a maximum of 1 watt power.
An AC voltage/ current source, and an ac inductive load.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
(Dc diagram shown, AC is similar).
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
In schematic diagrams this is the symbol for a fuse:
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
These devices are installed between the “hot” and “neutral” and protective ground.
so, what happens?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Upvotes:
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
I post the exact comment here.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
It seems Mohan does not understand the difference between a comment and an Answer.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Here is a simplified AC power diagram.
but I think this circuit , shows a few more pieces.
The bolt then partially travels down the line to your home.
One is “what exactly is in a ‘surge protector’ ? ”
There are three different concepts here that are getting confused.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is 'the assistant's answer'
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
[image of Common-mode choke]
what exactly is a ‘surge’ protector?
There are two important concepts here.